Qingdao Gute Ship Supplies Co., Ltd.

    Ship launching airbag, Marine water balloon ashore is most used in Marine airbag engineering technology.The technology does not need the traditional technology of slide or dock, don't need complicated mechanical equipment, able to finish the easiest fastest ship launching, ship to shore, can save a lot of investment and time for the customer.The technology do not take up space, especially suitable for the new factory or some temporary launching, ashore tasks, such as remote areas of the ship to shore repair project.For eager to expand the production capacity and subject to the new site and facilities of the shipyard, can the existing space ship, then the ship launching airbag technology in the water, the water can continue to use the open area.
    Ship launching airbag on shore, is the use of ship launching airbag jacking ships in the water, using the winch to pull ship to shore.The technology does not need to ramp and docks, particularly suitable for ship repair enterprises and or rescue and other applications.

1, Marine airbags are usually most needed a tide of change, at the high water level, let the ship as much as possible close to the shore, when low water beached near the bow position again, began in the Marine airbags, and pneumatic jacking bow.Then use winch to pull the boat to move forward, with hull mobile, more can be inserted at the bottom of the Marine airbags.Repeat the above steps, the final airbags carry the hull, under the hoist pull pull the boat ashore.After ship ashore, reach the desired location, with good support block, then the balloon is deflated and hull fell to support piers, end of the work.
2, determine the main factors of success on the Marine airbags include: hull weight, ship type, the bearing capacity of the ramp, slope, windlass tension as well as the tide and so on.Pull a boat ashore to overcome gravity and Marine hull gasbag of friction with the ground, so enough tension is to guarantee the success of the project the primary factor.Need to pull the ship ashore usually stay for a period of time in the water, bottom are generally accompanied by shellfish biology, need to clear before the project was carried out on the bottom.
3, usually ship to reserve position, on the need to use the cable to locate the hull.Marine airbags can be embedded in low water temporary inserts, in order to guarantee Marine air sinks, vacuum for Marine airbag.Marine airbag jack-up bow, if the contact area is lesser, jack-up difficulties that can be taken under the Marine airbag cushion sandbags and such measures to increase the contact area, thus improve the top lift.When the bow is jacking to feed more towards the stern ship airbag without contact to ensure that the stern and protect the hull, and avoid pulling resistance when the hull.For larger tonnage on the ship, it is necessary to design construction of special concrete ramp.